HIT-HY 170 Adhesive anchor

Hilti Fastener: HIT-HY 170 Adhesive anchor

Product Name：HIT-HY 170 Adhesive anchor
Content per can/cartridge：330ml/500ml
Base materials：Concrete (cracked), Concrete (lightweight), Concrete (uncracked),
Base material condition：Dry, Wet
Approvals / test reports：ETA, Seismic
Anchoring elements：AM rods, HAS-U threaded rods, HIS-N internally threaded sleeves, HIT-IC internally-threaded rods, HIT-SC mesh sleeves, Other fasteners, Rebar
Environmental conditions：
Coastal areas/roads with de-icing salt, Highly corrosive special applications (e.g. tunnels, swimming pools), Indoor, Outdoor
Cleaning procedures：Automatic cleaning (SafeSet hollow drill bit), Compressed-air cleaning, Manual cleaning
Storage and transportation temperature range：5 - 25 °C
In-service temperature – range：-40 - 80 °C

Quantity

Contact Now

add to cart

1. Product Overview – HIT-HY 170 Adhesive anchor
HIT-HY 170 Adhesive anchor delivers fast, versatile bonds in cracked or dry concrete.

ETA-approved for masonry & concrete C20/25–C50/60

Works wet or dry, –40 °C to +80 °C

330 ml / 500 ml cartridges fit standard guns

Styrene-free for safer job sites

2. HIT-HY 170 Adhesive anchorTechnical Parameters

Parameter	Specification	Notes
Cartridge volume	330 ml / 500 ml	Standard caulking gun
Base concrete	C20/25–C50/60	Cracked & uncracked
Base material	Lightweight, masonry	Also dry / wet
Service temp	–40 °C to +80 °C	Long-term +50 °C
Storage temp	+5 °C to +25 °C	Shelf-life 18 months

3. HIT-HY 170 Adhesive anchor Performance Data
*Values for cracked C20/25, no edge influence

Rod size	Embedment hef	Tension Nrd*	Shear Vrd*
M8	60 mm	7.2 kN	9.0 kN
M12	90 mm	16.5 kN	21.0 kN
M16	120 mm	28.0 kN	35.0 kN

Same bond in wet or water-saturated concrete

Quick cure: full load in 30 min at 20 °C

Resists coastal salt and de-icing salts

4. HIT-HY 170 Adhesive anchor Installation Guide

Step	Action	Tools/Requirements
1	Mark hole	Marker
2	Drill & clean	Hollow drill bit
3	Inject mortar	Dispenser gun
4	Insert rod	Twist slightly
5	Wait cure	20 °C 30 min
6	Tighten nut	Torque wrench

5. HIT-HY 170 Adhesive anchor Application Scenarios

Application	Recommended Spec	Conditions
Window bars	M8 × 60 mm	Cracked brick, outdoor
Sanitary fixtures	M10 × 70 mm	Wet bathroom concrete
Steel columns	M16 × 120 mm	C30/40 uncracked
Tunnel lighting	M12 × 90 mm	Salt-spray exposure

6.HIT-HY 170 Adhesive anchor Certifications & Compliance

ETA-15/0489 – cracked & uncracked concrete C20/25–C50/60

ETA masonry – clay brick, sand-lime brick, AAC

CE-marking – EN 1992-4 & ETAG 001

Tested in dry & water-saturated concrete

Send Message