Ring Joint Gasket

QS Gasket: Fujian Ring Joint Gasket

Ring Joint Gasket for bolted flange joints, fitted to the flange drawing.

Quantity

Contact Now

add to cart

One-Minute Overview

Ring Joint Gasket: even bolt load decides the seal, not thickness alone.
Face finish and flatness are inspected before the gasket is seated.
Compression is built up in several cross-pattern passes.
Dimensions, stack height and materials are confirmed per inquiry.

Most flange leaks trace back to assembly practice rather than to the gasket itself. Ring Joint Gasket has to be centred on the bore and compressed evenly if it is to hold both a tight seal and a stable joint over thermal cycles. Qishine checks the flange drawing, the bolt grade and the medium before confirming dimensions and materials per inquiry, then leaves the torque sequence to the flange and bolt specification supplied with the joint.

Name: Ring Joint Gasket
Note: Full dimensions and bolt pattern are confirmed per inquiry.

Start with the flange standard, facing and bolt circle, then confirm the bore clears the pipe ID. Choose the gasket construction for the medium and the expected bolt load, and check that the available sealing area is wide enough for the compression required. Final thickness, stack height and any ring details are confirmed per inquiry against the approved drawing.

Clean both faces, check for scoring and warping, and remove every trace of the old gasket. Seat the new gasket concentric with the bore, bring bolts up in a star pattern in at least three passes, and never reuse a gasket that has already been compressed. Recheck torque after the first heat-up and monitor for weeping when the line reaches operating pressure.

FAQ

Q1. How should the bolts be tightened?

In a cross or star pattern in several even passes, up to the torque set by the flange and bolt grade. A single uneven pass cocks the joint and leaves part of the gasket under-compressed.

Q2. What face condition is required before fitting?

Faces must be flat, clean and free of pitting, warping and old gasket debris. A scored face concentrates bolt load locally and gives the medium a path past the gasket.

Q3. Why recheck torque after start-up?

Thermal cycling and initial relaxation reduce bolt preload. A controlled recheck after the first heat-up restores compression before the joint sees full operating pressure.

Q4. What payment terms do you accept?

T/T, L/C at sight and other internationally accepted terms. The exact terms are agreed with you before production starts, because the payment schedule has to match the order value, the shipping method and the delivery schedule you need — which is also why we confirm them up front rather than after shipment.

Send Message