API 5L Seamless Pipe

QS Pipe: Yuyao API 5L Seamless Pipe

API 5L X70 seamless pipe, 8 inch SCH40, normal black surface, for long-distance oil and gas transmission, offshore risers and urban gas networks.

Quantity

Contact Now

add to cart

One-Minute Overview

API 5L seamless line pipe in X70 grade for high-pressure transmission duty.
8 inch SCH40 wall with a normal black surface as the standard finish.
Pierced from solid billet, so there is no weld seam or heat-affected zone.
Specified for long-distance oil and gas lines, offshore risers and gas networks.

API 5L seamless pipe is line pipe made without a weld: the body is pierced and rolled from a solid billet, which removes the seam and the heat-affected zone that comes with it. This item is the X70 grade in 8 inch SCH40 with a normal black surface, a common choice where a transmission line, a riser or a gas network runs at pressure that leaves no room for a seam-related defect. Ordering to API 5L also fixes the chemistry, the mechanical properties and the test regime, so the mill data package looks the same on every project.

Name: API 5L Seamless Pipe
Type: Seamless
Size: 8 Inch
Schedule: SCH40
Material: API 5L X70
Standard: API 5L
Surface: Normal Black
Application: Long-distance Oil and Gas Pipelines, Offshore Platform Risers, Urban Gas Networks
Size, schedule and grade are confirmed per inquiry, and a detailed specification sheet is available on request.

Selection begins with design pressure and the wall that carries it. SCH40 on 8 inch X70 covers a wide band of transmission duty, and the wall is checked against the design code before the line is ordered. The ends are cut square and bevelled to suit the welding procedure, and X70 is welded with matching consumables under a qualified procedure. Keep the pipe on dunnage, cap the ends against dirt and water, and inspect the black surface for handling damage before the line is lowered into the trench.

Inspection follows the API 5L route: chemistry and tensile tests on the heat, hydrostatic test on each length, and NDT where the service class demands it. The marking on the pipe body carries grade, size and heat number, so traceability holds from mill to site. For offshore risers and buried gas networks the black finish is treated as a base layer, with the project coating applied over it before installation.

FAQ

Q1. What does the X70 grade deliver over a lower line pipe grade?

X70 raises the yield strength, so the same design pressure can be held with a thinner wall than a lower grade would need, or the line gains reserve against surge and external load. The trade-off is that welding follows a qualified procedure with matching consumables, and forming stays inside the code limits.

Q2. Is the black surface enough protection, or do I need a coating?

Treat it as a base finish, not as corrosion protection. It keeps the surface tidy in transit and storage, but buried lines and offshore risers normally take a project coating over it. Above ground dry service can live with a black surface if the environment is mild and the pipe is kept dry.

Q3. ERW is cheaper, so why pay for seamless on this line?

Because some lines refuse to host a seam. High pressure, fatigue loading and critical risers are exactly where a weld, however well made, is the part you think about at three in the morning. Where the service is gentle and the code allows it, welded pipe does the job and saves money.

Q4. What's the minimum I can order for API 5L seamless pipe?

Standard flange insulation gasket kits start at one set, and standard gaskets, studs, washers and sleeves start at one piece. Kits made to your drawing or for a non-standard bolt pattern are quoted individually, because the minimum really depends on the material and the tooling involved.

Send Message