MCG Insulating Gasket Series

QS Gasket: Wuxi MCG Insulating Gasket

MCG Insulating Gasket Series specified from the flange drawing and bolt load.

Quantity

Contact Now

add to cart

One-Minute Overview

MCG Insulating Gasket Series: supplied against the flange drawing, not a catalogue label.
Bore, bolt circle and facing are checked before any dimension is fixed.
Material, construction and ring arrangement are confirmed per inquiry.
Full dimensions and thickness are verified against the approved drawing.

Selecting a flange gasket starts at the flange, not at a size label. The standard, facing and bolt circle set the available sealing area, and the gasket must compress within that envelope without crushing or extruding. MCG Insulating Gasket Series is specified against the flange drawing; Qishine confirms the material, construction and exact dimensions per inquiry before the gasket is cut, so the sealing face and the bolted joint work as one assembly.

Name: MCG Insulating Gasket Series
Note: Full dimensions and bolt pattern are confirmed per inquiry.

Provide the flange standard, face finish, bolt circle and bolt grade together with the medium the line will carry. From those inputs the gasket construction and material are chosen, then the bore is checked against the pipe ID. Final dimensions, thickness and any ring or coating requirements are confirmed per inquiry rather than assumed from a product name.

Inspect both flange faces for pitting and warping, clean away old debris and set the gasket concentric with the bore. Bring the bolts up in a cross pattern in several passes to the torque set by the flange and bolt grade, so compression stays even. Recheck torque after the first heat-up and confirm the joint holds at operating pressure before the line is handed over.

FAQ

Q1. Which drawings and data fix the gasket dimensions?

The flange standard and facing, bolt circle and grade, bore, process medium and operating conditions. Material, construction and final dimensions are confirmed per inquiry from those details; no grade is assumed here.

Q2. Why must the bore be checked against the pipe?

A bore that is too small restricts flow and erodes the gasket edge; one that is too large leaves unsupported area that can extrude under bolt load. The drawing fixes the bore before the gasket is cut.

Q3. Can the gasket be reused after the joint is opened?

No. Gasket materials take a permanent set under bolt load and cannot recover their original seal. Fit a new gasket each time the joint is opened.

Q4. What's the minimum I can order?

Standard flange insulation gasket kits start at one set, and standard gaskets, studs, washers and sleeves start at one piece. Kits made to your drawing or for a non-standard bolt pattern are quoted individually, because the minimum really depends on the material and the tooling involved.

Send Message