Install Simple Socket Weld Flange

QS Flange: Jiaxing Install Simple SW Flange

Install simple socket weld flange, 1 inch 300LB RF per ANSI B16.5, forged stainless steel, quick to fit and to open again for maintenance.

Quantity

Contact Now

add to cart

One-Minute Overview

Socket weld flange designed for quick installation and simple disassembly on 1 inch lines.
Forged stainless steel, 300LB, raised face, dimensioned to ANSI B16.5.
Good sealing performance in high-temperature, high-pressure service.
A natural fit for chemical plants, refineries and power generation piping.

The install simple socket weld flange is built around one promise: less time at the joint. The 1 inch pipe drops into the machined socket, the hub holds alignment while you tack, and a fillet weld completes the connection with a smooth bore left for flow. Forged stainless steel and a 300LB raised face give the joint the strength and seal that high-temperature, high-pressure service demands.

Name: Install Simple SW Flange
Size: 1"
Pressure: 300LB
Material: Stainless Steel
Flange Face: RF
Process Method: Forged
Standard: ANSI B16.5

Simple installation pays off twice: once on the first fit, and again every time the line is opened for inspection. Disassembly is straightforward because the joint stays accessible and the socket weld keeps the pipe from wandering during re-fit. The ANSI B16.5 dimensions mean the flange pairs with standard 300LB fittings and gaskets, and the raised face keeps leakage out of the picture in chemical plants, refineries and power generation service where the lines carry flammable or explosive gas or liquid. A joint that goes together quickly and comes apart cleanly is exactly what turnaround crews ask for.

FAQ

Q1. 'Install simple' — is that a real feature or just a nice name?

Fair question. It is real: the pipe drops into the socket, the hub keeps it aligned while you tack, and the fillet weld finishes the joint. Nothing needs the careful fit-up a butt weld demands, so crews spend minutes at the flange instead of an afternoon.

Q2. What standard and rating should the design team check?

The flange is dimensioned to ANSI B16.5 at 300LB with a raised face, so it pairs with standard 300LB fittings and gaskets. The forged stainless steel body and socket weld end are intended for high-temperature, high-pressure service carrying flammable or explosive gas and liquid.

Q3. Will it come apart easily when the line opens for inspection?

Yes, and that is half the point. The joint stays accessible and the socket weld keeps the pipe aligned on re-fit, so disassembly and reassembly stay quick. Add the raised face sealing, and maintenance crews get a flange that cooperates instead of fighting back.

Q4. What is the smallest order I can place?

Standard flange insulation gasket kits start at one set, and standard gaskets, studs, washers and sleeves start at one piece. Parts made to your drawing or to a non-standard bolt pattern are quoted one by one, because the minimum really depends on the material and the tooling involved.

Send Message