CS 16Mn Welded Pipe

QS Pipe: Jiangsu CS 16Mn Welded Pipe

CS 16Mn low alloy welded pipe, 1/2 to 36 inch and 0.5 to 20 m lengths, SCH40 wall for pressure lines needing toughness as well as strength.

Quantity

Contact Now

add to cart

One-Minute Overview

CS 16Mn welded pipe, 1/2 to 36 inch, lengths 0.5 to 20 m, SCH40 wall.
Manganese alloyed steel for higher yield and toughness in pressure duty.
Plain ends, black surface and end caps keeping both ends clean in transit.
A low alloy choice for petroleum lines that run cold or see cyclic load.

CS 16Mn welded pipe is the low alloy member of the welded carbon steel family. The 16Mn grade adds manganese to the chemistry, which raises yield strength and keeps toughness in the picture — exactly what a pressure line wants when it runs in cold weather or sees load cycles over its life. Sizes run from 1/2 to 36 inch with lengths from 0.5 to 20 m in SCH40 wall, so the same grade follows a project from small bypass lines up to main runs.

Name: CS 16Mn Welded Pipe
Type: Welded
Size: 1/2 to 36 Inch
Material: CS 16Mn
Standard: ASTM
Thickness: SCH40
Length: 0.5 to 20 m
End: Plain
Surface: Black

Choosing 16Mn is a decision about toughness, not just strength. Plain carbon steel gets stronger with carbon and simultaneously more brittle; the manganese route raises the strength while keeping the steel weldable and serviceable in the cold, which is why low alloy grades appear on lines that winter outdoors or carry pressure transients. Welding follows standard discipline — consumables matched to the base, controlled heat input and preheat for thicker walls — and the seam is examined non-destructively and hydrostatically before dispatch. Across a mixed size order, one material keeps procedure qualification and documentation in a single track.

Site handling is ordinary and worth doing properly: caps stay on until fit-up, bundles rest level and marked, and the black surface is protected where slings and chains bear. Size and wall thickness are confirmed per inquiry, and a detailed specification sheet is available on request.

FAQ

Q1. What does manganese actually change in this steel?

Manganese raises yield strength and helps the steel stay tough at low temperature without the weldability penalty of a big carbon increase. That combination is why 16Mn sits between plain carbon steel and heavier alloy grades on lines that need strength plus cold service.

Q2. How is 16Mn welded in the field?

With matched consumables, controlled heat input and preheat when the wall thickness and ambient temperature call for it. The chemistry welds predictably, but like all low alloy steel it rewards clean fit-up and a steady hand over speed. Follow the qualified procedure and inspect as specified.

Q3. Where does toughness matter more than raw strength?

Anywhere the steel sees cold, impact or cyclic load — buried lines in winter, pressure transients, pipe that gets knocked around during maintenance work. Strength without toughness is exactly how brittle failures happen, and the 16Mn balance is aimed at that gap rather than at raw numbers on a report.

Q4. What is the minimum order for CS 16Mn pipe?

Standard flange insulation gasket kits start at one set, and standard gaskets, studs, washers and sleeves start at one piece. Kits made to your drawing or for a non-standard bolt pattern are quoted individually, because the minimum really depends on the material and the tooling involved.

Send Message