CGI Spiral Wound Gasket Assembly

QS Gasket: Fujian CGI Spiral Wound Gasket

CGI Spiral Wound Gasket Assembly for flange joints, supplied against the flange drawing.

Quantity

Contact Now

add to cart

One-Minute Overview

CGI Spiral Wound Gasket Assembly: supplied against the flange drawing and sized to the mating flanges.
Winding, filler and ring configuration are confirmed per inquiry.
Bore, bolt circle and facing must match the mating flanges before fitting.
Dimensions, thickness and compression are verified against the approved drawing.

A spiral wound gasket seals by even compression of a metal winding and a filler layer between two flange faces. CGI Spiral Wound Gasket Assembly is specified against the flange drawing rather than a catalogue size, because bore, winding density and ring arrangement all depend on the mating flanges. Qishine confirms the winding, filler and ring configuration per inquiry before the gasket is cut.

Name: CGI Spiral Wound Gasket Assembly
Note: Full dimensions and bolt pattern are confirmed per inquiry.

Start from the flange standard, facing type and bolt circle shown on the drawing. Confirm the bore clears the pipe ID and that the winding and filler suit the process medium; where an inner or centering ring is required, its material and thickness are checked together with the gasket. Final dimensions are confirmed per inquiry.

Clean both flange faces, check flatness and remove old gasket debris, then centre the gasket on the bore. Bring bolts up in a star pattern in several passes so the winding compresses evenly; do not reuse a gasket that has already been compressed. Recheck torque after the first thermal cycle and confirm the joint holds at operating pressure.

FAQ

Q1. What determines the winding and filler for this gasket?

The flange standard, facing, process medium and bolt load fix the winding metal and filler. They are confirmed per inquiry against the flange drawing; no material grade is assumed here.

Q2. Why is an inner or centering ring sometimes specified?

An inner ring protects the winding from radial buckling and erosion, while a centering ring locates the gasket within the bolt circle. Which rings are required is confirmed per inquiry from the flange drawing.

Q3. Can a spiral wound gasket be reused after opening the joint?

No. The winding takes a permanent set under bolt load, so a compressed gasket cannot recover its original seal. Fit a new gasket each time the joint is opened.

Q4. How long will production take?

Standard sizes are typically ready within 30 days, and in-stock items ship immediately. Larger or custom orders get a confirmed date per order, because the schedule depends on quantity, material, the bolt pattern you specify, and how busy production is at the moment you order.

Send Message