ASTM A53 Seamless Pipe

QS Pipe: Quanzhou ASTM A53 Seamless Pipe

ASTM A53 Type S seamless pipe, 5 inch SCH40 in custom lengths with plain ends for general pressure and mechanical service.

Quantity

Contact Now

add to cart

One-Minute Overview

ASTM A53 seamless pipe in 5 inch size, SCH40 wall, cut to custom lengths.
Type S seamless construction for bending, flanging and general pressure service.
Plain ends with a normal black surface and caps fitted at both ends.
A general duty carbon steel pipe for petroleum, water, gas and air lines.

The A53 seamless pipe in 5 inch SCH40 is the general duty choice of the carbon steel family. A53 covers both seamless and welded pipe for mechanical and pressure service, and the seamless type brings a uniform wall to lines that get bent, flanged or rolled into a spool. Five inch is a common size for plant headers and transfer lines, and cutting to custom length means the pipe arrives ready for the drawing instead of leaving a drop to store and rework.

Name: ASTM A53 Seamless Pipe
Type: Seamless
Size: 5 Inch
Material: A53
Standard: ASTM
Thickness: SCH40
Length: Custom Size
End: Plain
Surface: Normal Black

Where this pipe earns its keep is versatility. The same 5 inch SCH40 length can carry petroleum product, water, gas or air, and the seamless wall tolerates the cold bending and flanging that welded pipe sometimes fights. Dimensional consistency along the length is the quiet advantage: outside diameter and wall stay within tolerance from end to end, so fittings seat predictably and a fabricated spool goes together without grinding out high spots. Acceptance follows the normal route for pressure pipe — hydrostatic testing plus dimensional checks — so the pipe fits a documented line specification.

Installation keeps the same discipline as other plain end carbon steel pipe: square cuts, clean bevels, a dry joint before welding and caps removed only at the moment of fit-up. Store lengths on level supports to avoid a permanent bow, and protect the black surface where slings and chains bear, since a deep scratch is where corrosion starts in outdoor storage. Size and wall thickness are confirmed per inquiry, and a detailed specification sheet is available on request.

FAQ

Q1. What is the difference between A53 Type E and Type S?

Type E is electric resistance welded and has a longitudinal seam; Type S is seamless, made from a pierced billet with no weld at all. Same specification, different construction. Type S takes bending and flanging more kindly and suits cyclic or fatigue-sensitive lines, while Type E is usually the economical route for straight, steady pressure service.

Q2. Can I cold bend this pipe on site?

Yes, within reason. A53 seamless handles cold bending better than most welded pipe because there is no seam to buckle or thin unevenly. Use a proper bender with the right radius for the wall, and inspect the intrados for wrinkles afterwards. If the bend is tight or the wall thin, an induction hot bend is the safer route.

Q3. Does SCH40 mean the same wall on every size?

No. SCH40 is a schedule designation, not a fixed thickness in millimetres, so the wall grows with the nominal size. On 5 inch it is a substantial wall for pressure work. Always confirm the actual wall your line calculation assumes, and let the order carry both the schedule and the value.

Q4. How long will production take for custom length A53 pipe?

Standard sizes are typically ready within 30 days, and in-stock items ship immediately. Larger or custom orders get a confirmed date per order, because the schedule depends on quantity, material, the bolt pattern you specify, and how busy production is at the moment you order.

Send Message