ASTM A333 Seamless Pipe

QS Steel Pipe: Ningbo ASTM A333 Seamless Pipe

ASTM A333 Gr.6 seamless low-temperature pipe, 60 mm size with 12 mm wall, impact tested for cold service down to minus 45 degrees Celsius.

Quantity

Contact Now

add to cart

One-Minute Overview

ASTM A333 Gr.6 seamless pipe, 60 mm size with 12 mm wall for cold service.
Impact tested toughness holding down to minus 45 degrees Celsius.
Seamless construction for LNG, cold vessels and low-temperature exchangers.
Normal blue surface; residual elements kept low so the pipe stays weldable.

This A333 Gr.6 seamless pipe is built for the cold end of the business. Low-temperature service is where ordinary carbon steel turns brittle — the same pipe that behaves well at ambient can crack like glass once the metal falls below its ductile-to-brittle transition — and A333 is the specification written to prevent exactly that. Grade 6 is the carbon steel member of the family, impact tested to prove toughness at the temperature it will actually see, in this case service down to minus 45 degrees Celsius. The 60 mm size with a 12 mm wall is a robust pressure section for low-temperature vessels and heat exchangers.

Name: ASTM A333 Seamless Pipe
Type: Seamless
Size: 60mm
Material: A333 Gr.6
Standard: ASTM
Wall Thickness: 12 mm
Surface: Normal Blue
Application: For Low-temperature Pressure Vessels and Heat Exchangers at -45℃

Toughness at temperature is the whole argument. Impact testing is what separates A333 from ordinary pipe — the material is tested at low temperature so buyers know how much energy the steel can absorb before it fractures, and chemistry is held with residual elements limited so the grade welds predictably in the field. Seamless construction adds the usual advantage at pressure: a uniform 12 mm wall with no weld line running through a section that may see thermal shock during cooldown or a pressure surge during startup. The normal blue finish protects the tube through shipping and storage and is removed at weld preparation.

Installation in cold service has its own rules: dry the joint before welding, follow the qualified low-temperature procedure including any impact requirements for the weld metal, and avoid sharp notches in handling that could become crack initiators once the line is cold. Size and wall thickness are confirmed per inquiry, and a detailed specification sheet is available on request.

FAQ

Q1. Why can ordinary carbon steel fail in cold service?

Below its transition temperature, plain carbon steel loses the ability to deform before it breaks — a small defect or notch can run into a brittle fracture with little warning. A333 Gr.6 is chemistry-controlled and impact tested so the steel still absorbs energy at the temperature the line will actually see.

Q2. What does the impact test prove?

It measures how much energy the steel absorbs when struck at low temperature, which is a direct proxy for toughness. Specimens are tested at the service temperature or below, so the number reflects the pipe's behaviour in the cold rather than a room temperature hope.

Q3. Is welding different on low-temperature pipe?

The procedure is. Low hydrogen consumables, controlled heat input and weld metal that meets impact requirements at the service temperature are all part of it. Weld the joint as if it will spend its life at minus 45, because it will.

Q4. What is the minimum order for A333 low-temperature pipe?

Standard flange insulation gasket kits start at one set, and standard gaskets, studs, washers and sleeves start at one piece. Kits made to your drawing or for a non-standard bolt pattern are quoted individually, because the minimum really depends on the material and the tooling involved.

Send Message