ASTM A106 Welded Pipes

QS Pipe: Xiamen ASTM A106 Welded Pipes

ASTM A106 welded pipe, 4 inch SCH40 in 6 m plain end lengths with a tested seam for warm petroleum piping runs.

Quantity

Contact Now

add to cart

One-Minute Overview

ASTM A106 welded pipes, 4 inch size in SCH40 wall and 6 m stock lengths.
Welded construction where the longitudinal seam is tested before it ships.
Plain ends with a normal black surface and caps fitted at both ends.
A106 grade steel for petroleum lines that run warm and stay in service for years.

This A106 welded pipe answers a practical question: what do you run when the service is warm and the budget is real? The pipe carries A106 grade steel in a welded construction — 4 inch, SCH40 wall, 6 m lengths, plain ends, normal black surface. A106 is written for high-temperature service, so the chemistry and mechanical values sit above ordinary plumbing grades, while the welded route keeps the cost and lead picture friendly for straight runs that do not need the last word in fatigue life.

Name: ASTM A106 Welded Pipes
Type: Welded
Size: 4 Inch
Material: A106
Standard: ASTM
Thickness: SCH40
Length: 6 m
End: Plain
Surface: Normal Black

On a welded pipe the seam decides the reputation. The longitudinal weld is made under controlled parameters and then put through non-destructive examination plus a hydrostatic test, so what arrives on site is a length whose weak line has already been interrogated. Six metre stock lengths are the logistics sweet spot: long enough to keep field joints down on a typical rack run, short enough to truck and stage without special handling. Welders preparing these plain ends should follow the qualified procedure for A106 grade, including any preheat the thickness and ambient temperature call for.

Choose this welded A106 where the line is warm rather than blazing, where runs are straight and the number of joints matters more than peak fatigue performance. Keep the caps on during transport, store bundles clear of standing water, and mark cut lengths as the spool comes together so traceability stays with the pipe. Size and wall thickness are confirmed per inquiry, and a detailed specification sheet is available on request.

FAQ

Q1. Is A106 welded pipe the same as seamless A106?

Same grade, different construction. Seamless A106 is a pierced tube with no weld; this pipe is welded from A106 grade steel and the seam is tested before delivery. For high cyclic or peak temperature duty seamless still leads, but for warm steady service a tested welded seam is a sound, economical answer.

Q2. What should I check on the weld seam before installation?

Read the inspection documents first: the hydrostatic test is standard, and non-destructive examination appears when the order calls for it. On site, look the seam over for arc strikes or handling damage, and keep the root gap consistent when you fit the joint — most field problems start as fit-up problems, not mill problems.

Q3. Why do the end caps matter so much on plain end pipe?

A plain end is a machined face waiting to be welded. A dented end, a rust bloom or a grit packed bore costs real time in bevel cleaning and fit-up, and sometimes a whole cut-back. Caps are cheap; grinding out a damaged end at height is not. Keep them on until the pipe is in the clamp.

Q4. How long will production take for these A106 welded pipes?

Standard sizes are typically ready within 30 days, and in-stock items ship immediately. Larger or custom orders get a confirmed date per order, because the schedule depends on quantity, material, the bolt pattern you specify, and how busy production is at the moment you order.

Send Message